page_banner

Andritz Pellet Mill Die/Agricultural Processing Equipment long Working Life Vertical Various Series ring Die Creep Feed Andritz Pellet Mill Die

Andritz Pellet Mill Die/Agricultural Processing Equipment long Working Life Vertical Various Series ring Die Creep Feed Andritz Pellet Mill Die

Creep feed (commonly known as milk substitute, artificial milk), is a kind of feed pellet which replace the whole milk, its main raw material is dairy by-products. The nutritional index of substitute milk material is protein not less than 20%, fat is more than 6%. The particles are relatively fluffy and can be crushed with fingers. There are many factors that affect the quality of granule, among which the formula factor is dominant


Product Detail

Product Tags

Creep feed (commonly known as milk substitute, artificial milk), is a kind of feed pellet which replace the whole milk, its main raw material is dairy by-products. The nutritional index of substitute milk material is protein not less than 20%, fat is more than 6%. The particles are relatively fluffy and can be crushed with fingers. There are many factors that affect the quality of granule, among which the formula factor is dominant. At present, the creep feed pellet mill die hole size is φ1.6-3.0mm, compression ratio 1:3.5-1:5 is in the majority. There will be a certain degree of expansion when the particles are extruded from the pelleting hole, and excessive extrusion in the pelleting hole will increase the feed temperature a lot. The heat-sensitive substances in the formula will be coking, resulting in the hardening of the feed particles ,particle size be different and poor surface finish of the particles. Our Happy Mould adopt a special creep feed pellet mill die production process, which solve the problems of the surface finish and pellets different sizes.

Famsun 600 screw type creep feed ring die

The procedure for installing the ring die shall be as follows:

(1) Cut off the power supply; Adjust the cutter away from the ring die to avoid collision.
(2) Adjust the drum away from the ring die.
(3) Clean thoroughly the end face, the surface and inner surface of the hoop which fit the ring die; Completely clean the matching surface of the ring die driving the rim.
(4) Fix the ring die lifting device on the ring die screw hole, and then lift it to the corresponding installation height.
(5) Adjust the height of the ring die to move the drive rim, and ensure that the key slots are aligned with each other to ensure that the ring die is evenly installed in the drive rim.
(6) Install the hoop pieces one by one.
(7) Properly adjust the gap between the two press rollers and the ring die.
(8) Install clean rotary feed cone on the outside - ring die end face in turn.
(9) Install the access door on the right side of the pellet mill.
(11) Close the access door of the pelletizer.
(12) Adjust the cutting knife to the distance required by the ring die.

一  Andritz 420 hoop type creep feed pellet mill die

Andritz 420 hoop type creep feed pellet mill die

pig food processing machines

pig food processing machines

pig creep feed pellet machine

pig creep feed pellet machine

pig creep pellets mill die

pig creep pellets mill die

Pellet mill die for making weaned pigs feed

Pellet mill die for making weaned pigs feed

creep feed

pig creep feed pellet machine

φ3.0 Andritz420 compression ratio 1:9 ring die

φ3.0 Andritz420 compression ratio 1:9 ring die

Famsun 600 screw type creep feed ring die

Apply For Famsun 600 screw type creep feed ring die


  • Previous:
  • Next:

  • Write your message here and send it to us